Record Power WG250 Instruction Manual download pdf (Page 16)

Original Instruction Manual | WG250 Wet Stone Sharpening System | Version 3.0 | November 201216

Starting Operation

• You can start and stop the machine with the ON/OFF

switch (I).

• The machine has variable speed 90-150 min¯¹ to adapt to

various sharpening and honing applications.

• With the variable speed control knob (H) the best suitable

speed can be chosen.

• As the diameter of the Sharpening Stone reduces during

use the variable speed allows the user to compensate for

it and select the optimum speed for the

sharpening application.

Machine Operation

• Always wear appropriate clothing and personal

protection equipment.

• Use safety goggles at all times.

• Never place your hand near the machining area, grinding

stone and honing wheel while machine is in operation.

• Flying sparks can occur when grinding dry. They can cause

injury and ignite flammable materials.

• Remove defective abrasive wheels immediately.

• Tools are sharp and can lead to severe injuries, always

handle them with care.

• Make certain the switch (I) is in the OFF-position before

connecting the machine to the power supply.

In the Event of a Blockage or if the

Machine Stalls

If the machine stalls due to the work piece or other foreign

body becoming trapped, switch the machine of immediately

by pressing the red button on the switch marked ‘O’.

Locate and rectify the source of the blockage. If the work

piece has become trapped between the sharpening stone

and the jig, the surface of the stone may become damaged.

It may be necessary to dress or true the stone following

the procedure set out in section 9 and 10.5 of this manual,

before attempting to use the stone again.

Check that the sharpening stone can be turned freely by

hand before attempting to re-start the machine. Re-start

the machine by pressing the green button on the switch

marked ‘I’.

In the Event of a Power Failure

In the event of a power failure, first switch the machine off

by pressing the red button marked ‘O’ on the switch.

Locate and rectify the source of the failure. If the fault is

within the power circuit of the workshop, there may be

an underlying cause (circuit overload etc.) that should be

investigated by a qualified electrician, before attempting to

restore the power source.

Once the power is restored, re-start the machine by

pressing the button marked ‘I’ on the switch.

9. Set up and Adjustment

A B

F G

N A O

S T

Note: All operations described in this manual,

including the trueing and dressing of the sharpening

stone, must be carried out with sufficient water in the

trough to ensure the stone remains wet during use.

This is to ensure no damage to the sharpening stone

or items being sharpened occurs.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments

Record Power WG250 Instruction Manual Page 16

Comments to this Manuals