Record Power WG250 Instruction Manual download pdf (Page 34)

Original Instruction Manual | WG250 Wet Stone Sharpening System | Version 3.0 | November 201234

Changing the Sharpening Stone

If the sharpening stone (C) is worn down to a diameter of

approximately 150mm it needs to be replaced.

1. Disconnect the WG250 from the power source.

2. Loosen the Nut (M) and remove the old

sharpening Stone.

Changing the honing wheel

1. Disconnect the WG250 from the power source.

2. Loosen the lock knob (N) and remove the worn honing

wheel.

3. Install the new leather honing wheel (A)

4. Pay attention that the 3 drive pins engage with the

friction drive wheel (O).

5. If the leather strop wheel seems to wobble, please try

rotating it to the next pin location.

6. Tighten the lock knob (N)

11. Maintenance - Cont.

A B

F G

N A O

S T

A B

F G

N A O

S T

Note:

That the lock nut (M) has a left hand thread i.e. turn

clockwise to loosen, turn anti-clockwise to tighten.

3. The new Sharpening Stone has to meet the correct

technical specification. Always use a genuine

replacement stone.

4. Check abrasive wheel for flaws (e.g. cracks) before

installation. Do not use faulty wheels.

5. Install the new Sharpening Stone (C).

6. Place a washer (L) on each sides of the sharpening stone

and tighten the nut (M).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Record Power WG250 Instruction Manual Page 34