Record Power WG250 Instruction Manual download pdf (Page 13)

8. Assembly

• If you notice any transport damage while unpacking,

notify the supplier immediately.

• Dispose of the packing in an environmentally

friendly manner.

• Clean all rust protected surfaces with a mild solvent.

Remove the Transport Lock

There is a foam block inside the machine that is used

during shipment to keep the motor shaft from resting on

the drive wheel.

Please remove the storage drawer (E), turn the machine on

its side, and remove the internal foam block

before operating.

Mount the Sharpening Stone

1. Install the Sharpening Stone (C) on the shaft (K).

2. Place a washer (L) on each side of the Sharpening Stone

and tighten the lock nut (M).

A B

F G

N A O

S T

Note:

That the lock nut (M) has a left hand thread i.e. turn

clockwise to loosen, turn anti-clockwise to tighten.

Note:

To protect the drive wheel in transit, a plastic sleeve is

fitted to the motor shaft. This sleeve must be removed

before attempting to use the machine. It is necessary

to unscrew the torque adjusting knob to release the

pressure of the motor shaft against the drive wheel

and then remove the honing wheel to gain access to

the motor shaft. See opposite.

Plastic

sleeve

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Record Power WG250 Instruction Manual Page 13